You can contact us if you have any questions sales@fedar-printer.com +86-158 3835 8793

Hot Products

How to Maintain The Digital Dye Sublimation Printers in Winter

12/24 2021
Recently, the weather conditions across the country have changed a lot. Affected by a new round of cold air, most regions of our country have ushered in strong wind cooling weather, and the cooling rate in some areas can even reach about 10~14℃. Faced with such a cold winter, will you maintain your digital printing machine? Today, Fedar Textile Printing will introduce to you how to maintain the digital printing machine in winter, which can save you a lot of maintenance costs.
1. Nozzle: The nozzle is the core part of the printing machine. You must be extra careful during daily cleaning and maintenance. First clean the moisturizing sponge with cleaning fluid, then soak the sponge with the cleaning fluid, and move the printer head back to the rightmost ink stack. And make the nozzle and moisturizing sponge tightly integrated, to avoid the sponge from being too dry to ensure the cleaning and moisturizing of the nozzle.
2. Guide rail: After turning on the power of the printing machine every day, let the trolley drive back and forth several times, the dirt in the guide rail slider will remain on the guide rail, repeat several times, and then use a paper towel or cotton swab to apply a small amount of alcohol to wipe the stains. In addition, it is recommended to use lubricating oil to maintain the guide rail once every two weeks, and wipe the guide rail with a cotton swab moistened with a little lubricating oil to ensure the smooth lubrication of the guide rail and the smoothness of the next use.
3. Grating: This is also a component that many people tend to overlook. The grating is a transparent film behind the small frame of the digital printing machine, which mainly plays a role in positioning. If the grating is dirty, there will be ghost images. Dip a cotton swab with an appropriate amount of alcohol for wiping. Clean both sides and do not use brute force.

texitle printer /tshirt printer /sublimation printer

Winter first means low temperature. The obvious effect of temperature drop on the digital printing machine is that the print head is prone to “clogging”, which leads to broken lines and skipped stitches in printing. This phenomenon will be resolved after the nozzle is cleaned. This is because the viscosity of the ink increases as the temperature decreases, and the ink droplets condense on the nozzle holes.
At the same time, the temperature is low in winter, and the relative humidity is also lower. Dry air can easily cause the digital printing machine to print edges and rub paper. In severe cases, it may cause damage to the nozzle and motor.
Therefore, we must pay special attention to the temperature and humidity values ​​in the operating room. The suitable working temperature range of the photo machine is 18℃-30℃, and the humidity value is between 35%-65%. At the same time, in the winter environment, do not place the photo machine in an outdoor environment. If the temperature in the operating room of the photo machine is low, air conditioning can be appropriately used for heating and humidification.
+86-158 3835 8793 sales@fedar-printer.com